0
What else can I help you with?
My fingers slipped of the key when I tried to start it and now theres no power to the the ignition I changed the starter battery and the ignition switch and still nothing What could it be?
u might have broke something the actual ignition lock cylinder, that would be my guess from the sounds of it.
How do you change an ignition switch for a 1997 Nissan pickup?
I have changed an ignition in one. I used a pneumatic cut-off wheel to cut straight slots in the blank faces of the two bolts that retain the lock cylinder. Then, I used an impact screwdriver to remove the bolts. when you get the new ignition lock cylinder, you can use a large flat screwdriver to re-install the bolts.
How do you know if your key is bad 1992 Cadillac?
If the key will turn in the ignition cylinder, the only other fault the key can have is a missing or damaged resistor. The resistor is in the middle of the key and looks like a small black oval. The resistor has one of 16 specific values and is "read" by the Pass-key module. If you have a vehicle with 30K or more on the odometer that won't start, and everything else is good, (battery, starter etc…), the most likely problem is the two little wires that connect the Pass-key module to the ignition cylinder. These wires have to flex each time the cylinder is turned and eventually break at the ignition cylinder. The only reliable repair is to replace the ignition lock cylinder and key. New Ignition lock cylinders do not come with real ignition keys, only a temporary key to identify the cuts. If the cylinder is changed you have to purchase a new key separately to match the old key resistor and then cut to match the new lock cylinder.
You changed the starter on your 1994 Pontiac Bonneville and the car still wont start?
You should check the wires that are in the steering column to the ignition lock cylinder. They tend to break easily.
Does the ignition key for a 1996 ford ranger also unlock the door or is a separate key needed?
It only uses ( 1 ) key , unless a lock cylinder has been changed
Why do my flashers stay on because I changed my ignition?
It would help if we knew the year, make and model. It has to be something you did when you changed the ignition.
Do you have to reprogram the 97 preludes after the ignition switch is changed?
No, you do not.
When do ignition switches need to be changed?
When they develop a fault.
2006 Chevy Colorado 5cyl sometimes i have trouble starting it Turn the key let go of it and it keeps on like I'm holding key too long It acts like it wants to start but wont but will 10 min later?
Your having a problem with the passlock system. Contact your dealer and thell them the situation. They will need to change the ignition cylinder. I had this problem a couple fo years age and it took 5 trips to the dealer before they got it right. They changed the computer module , some sensors, and many other things. But, changing the ignition cylinder did the trick.
Why does a 1998 wrangler stall when you slow for curves and stop at stop signs it is an automatic 6-cylinder?
possibly due to loss of ignition... When was the last time you changed plugs wires coil etc...? check that first...
Can a motorcycle ignition switch be changed out with a universal one?
sure it can
Code saying cylinder 1 misfire also misfire in first 1000 revolutions you have changed the coil and all plugs?
Misfire Answer Faulty: spark plug, spark plug wire, ignition coil, ignition module, fuel injector are the most common. Coolant leaking into a cylinder is another. Internal engine problems such as burnt valve, broken valve spring, bent push rod, worn rings
