A single click when trying to start the engine is usually an indication of a loose battery cable/wire or a faulty starter solenoid/relay switch.
timing belt broke n changed it now bottom crank doesnt turn all way round it s hitting something on a dodge caravan 2000 3.0
It is on the front of the crank shaft. It seals the oil at the crank pulley.
It does not have a crank sensor, it only has the "pick up" plate in the distributor.
crank sencer, coil pack, or ecm
No crank sensor, only the sensor in the distributor.
It is on the top rear of thetransmission bell
Code 11 is " No crank reference signal at PCM"
my van will crank, but won't start, had spark plugs change
The Crank sensor is located on the transmission housing near the top at the back of the engine.
antifreeze is more likely to be leaking from the water pump and running down where it appears to leaking from crank pulley
if it doesnt have a crankshaft sensor then you have a distributer pick up. Its under your distributer cap.
It is in the top rear of the bell housing,