0
What else can I help you with?
How do you install wind shield wiper motor on 95 Chevy silverado?
Locate the old motor. Remove the mounting bolts and disconnect the wires. Installation is reverse of removal.
How do you locate and change the thermostat in a 2001 Chevy Malibu?
follow the upper radiator hose to locate it. Then unbolt required screws, remove old one, install new one. There will be anti freeze in the hose, so do this with engine cold or drain the coolant.
How can you locate the screw to install the ignition on a 1965 Chevy Impala?
www.truckandcarshop.com lowest prices, and they ship nationwide
How do you install fuel pump in 2005 Chevy Silverado?
remove fuel tank.
How do you install a heater core in a 1998 Chevy Camaro?
Remove the water from your 1998 Chevy Camaro cooling system. Remove the water supply hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
Where do you locate the gas pump on a Chevy caveliar?
It is inside of the fuel tank. You will have to remove the gas tank to get to it.
How do you install a starter on a 1993 Chevy Corsica?
Begin by removing the positive cable from your 1993 Chevy Corsica battery. Remove the cables on the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
How do you replace a serpentine belt in a 1991 Chevy truck?
How to remove and install the serpentine belt on 1991 Chevy Blazer with AC?
How do you install a fuel pump for Chevy cavalier 2000?
Remove fuel tank for access
Eliminate AC compressor 1994 Chevy pickup?
Remove it, and install a shorter belt.
2001 Chevy Metro lsi you need help in the removal and the installation of this water pump?
I am tring to remove and install a water pump on a Chevy metro 2001 lsi.I would like some advice on how to remove and install a water pump.Thanks.
How do you remove starter on 2005 Chevy Cobalt?
To remove the starter on a 2005 Chevy Cobalt, first disconnect the negative battery cable to ensure safety. Then, lift the vehicle and remove any necessary components for access, such as the splash shield. Locate the starter, disconnect the wiring harness and the mounting bolts, and carefully remove the starter from the engine. Finally, reverse the process to install the new starter, ensuring all connections are secure.
