It sounds like the mounting bolt has pulled through. If you hear the motor, you will only have to remount the motor. Take the door apart and find a large washer to put on the bolt to keep it from pulling through the motor mount. I have had to do this on 2 of my windows so far.
There is a diagram, for the power window system, for your 1995 Oldsmobile. The diagram can be obtained from most General Motors dealerships.
If the driver's window on a 1997 Oldsmobile Achieva isn't working while the other three windows are functioning, it could be due to a faulty window motor or a broken window regulator specific to that door. Additionally, issues with the driver's side window switch or wiring harness could also cause the problem. It's advisable to check for power at the switch and inspect the components for any visible damage or wear.
where is the fuse and relay for the power windows on a 2002 Oldsmobile alero
The Camshaft Position Sensor is located behind the Power Steering Pump.
push the button
you don't you replace it
In an Oldsmobile Achieva, the power steering belt is located on the front of the engine, typically in the accessory drive belt system. It connects the power steering pump to the engine's crankshaft pulley. To access it, you may need to remove any engine covers or components obstructing the view. Always refer to the vehicle’s service manual for specific details related to the model year.
apparently the window motor is bad and will need replaced.
The button on the driver's door that disables all windows except the driver's window. Push that button and all power will be restored to all windows. If not, that button may be defective.The button on the driver's door that disables all windows except the driver's window. Push that button and all power will be restored to all windows. If not, that button may be defective.
Remove the 1998 Oldsmobile power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.
How to repair power window in 2000 Ford Ranger passenger window will not work with either drivers button or passenger button the relay does not make any clicking noise either What is wrong?
Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.