I just took my 97 sebring convertable in for no turn signals, wipers, rear defroster and radio. They replaced the ignition switch and now everthing works.
The turn signals are not programmable.
turn signals won't work. changed all the bulbs. Hazard lights work. 1999 Chrysler Sebring hardtop
If the bulbs and fuse are good, replace the turn signal Flasher Relay.
the flasher that causes the turn signals to flash But where is the flasher located on this car?
front or rear turn signals
Flasher is faulty.
yes
In a 2008 Chrysler 300, the fuse box for the turn signals is located in the engine compartment. You can find it on the driver's side, near the battery. The specific fuse for the turn signals is typically labeled in the fuse box cover, so be sure to check the diagram provided there for the exact location.
In a 1994 Chrysler LeBaron, the fuse for the turn signals is located in the fuse box, which is usually found under the dashboard on the driver's side. The flasher for the turn signals is typically located in the same area, often near the steering column or behind the dashboard. You may need to remove a panel or cover to access these components. Always refer to the owner's manual for specific diagrams and locations.
I asked my dealer the same question and he said there is no fuse for the turn signals. There is a flasher assembley. If you think you blew a fuse check the flasher assembley but where is that?
There are 2 separate flashers.jd
You have a short in the wiring or at one of the bulb assemblies.