0
What else can I help you with?
Why does your 84 z die when accelerating Ignition coil has been replaced fuel pressure is good Is there a sensor doing this?
You have an ignition Control Module that you can check that controls ignition timing Throttle Position Sensor that tells the computer where the throttle is so it can regulate and give the correct air fuel ratio.
On 91 Geo Metro Convertible .Why do you have to run a hot wire to the coil to get it to run.I have replaced the ECU and that did not work?
Does it have an ignition control module? That may be the cause. Or possibly a MAP sensor or a Crank position sensor or Cam position sensor. Check those first.
What if your 86 bronco ll will not start evn though you have replaced the battery and ignition coil?
it could be the control module
Where is the location of ignition control module for Jaguar XK8?
Where is the place of the canshaft position sensor in1998 xk8
Can you change the distributerless on a 1989 Chevy Celebrity?
You can replace the ignition control module and the crankshaft position sensor as required.
No spark on a 1996 Ford F-150 5.8L?
If there is no spark on a 1996 Ford F-150 5.8L engine, it could be due to a faulty ignition coil, distributor cap, rotor, ignition control module, or crankshaft position sensor. Start by checking the ignition coil for any signs of damage or wear. Next, inspect the distributor cap and rotor for cracks or carbon tracking. Ensure the ignition control module is receiving power and functioning properly. Lastly, test the crankshaft position sensor for proper operation. If any of these components are faulty, they may need to be replaced to restore spark to the engine.
What is the location of the crank position sensor on a 1990 Firebird 3.1?
it does not have a crank position sensor. it uses the ignition control module as a crank sensor. it is in the distributor cap
What is the camshaft position sensor on a Chrysler pt cruiser?
It is a sensor that reads the rotational position of the camshaft. The engine computer uses that to control ignition and fuel timing.
Can a camshaft position sensor cause car to stall?
it can, but i would check the ignition control module first....then the crank sensor.....
Would a bad coil pack cause a crank sensor code?
Yes it very well could, because a misfiring coil pack or weak coil pack can cause interruptions in the signals to both the camshaft position sensor into the crankshaft position sensor. I had this happen on my Buick LeSabre, it gave a code 18, which is Cam / crank position sensor error okay. I replaced all three coil packs, and it went away and never came back. If you look at the diagram for the wiring of your ignition control module, you'll see that the coil packs, ignition control module, and camshaft and crankshaft position sensors are all interconnected.
How do you adjust the timing on 98 gmc safari van?
The distributor is located in a fixed, non-adjustable position. Ignition timing is preset and cannot be adjusted. Ignition timing is controlled by the powertrain control module.
Where is the crankshaft sensor on a 1984 Chevy Celebrity 2.8L?
It does not have one. Crankshaft position sensors are used in distributorless ignition systems to tell the ignition control module where the crankshaft is in its rotation. The 1982 thru 1986 2.8L engines had distributors so they had no need of a crankshaft position sensor.
