answersLogoWhite

0


Best Answer

Knocking noise in the engine may be as a result of excessive backlash, misaligned gears and worn timing chain. Blowing of excessive oil pressure could be as a result of stuck regulator.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: 1998 Chevy Silverado engine knocking and blows oil filter seals excessive oil pressure?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is engine knocking?

Cause low pressure oil pump


2003 silverado 2500hd 6.0 fuel pressure specs?

The 2003 Chevrolet Silverado 2506.0 liter engine fuel pressure should be between 15 pounds and 18 pounds. The specifications are for a new engine.


What is wrong if your '96 Camaro has no oil pressure and there is a knocking from the engine?

The bearings on the crankshaft are worn out. A complete engine overhaul is needed.


Where is the oil pressure switch on 91 silverado 350?

The oil pressure on 91 Silverado 350 is at the rear of the engine on the driver's side, This unit is usually found above the oil filter.Ê


Why is the Air vent knocking on my 1991 silverado when you turn the engine on or off?

your fresh air door is sticking open or closed and the motor is trying to open or close it


Knocking in the bottom of the engine?

knocking noise


Why cressida1989 engine knocking at 1500rpm to 3000rpm?

Could be the EGR valve not opening and causing the engine to detonate/ping due to excessive engine combustion chamber temperature or knock sensor not retarding timing. And could be engine bearings.


Where is the vacuum line on a 2000 Chevy Silverado engine?

The vacuum lines on a 2000 Chevy Silverado run between the intake manifold and multiple valves across the top of the engine. The vacuum pressure is generated by the engine's compression.


What is Silverado 5.7 engine psi?

Need to know the year. Oil pressure ? Or cylinder compression ?


What would cause a 300 CI 6cyl to Knock in a 1985 F150?

if the engine is knocking you could have bad support bushings for the mouter mounts or your engine could be warped do to excessive heat wear


What do you mean by engine blowby in automobile section?

Blowby is a condition to where you have excessive pressure in the crankcase of an engine usually from worn piston rings. A faulty PCV system can also cause excessive engine blowby.


Why is your engine knocking on BMW745?

knocking as in spark knock? or engine knock? spark knock is adjusted through a knock sensor via ignition timing. eng. knock is due to brg. knock as in low oil pressure or sluge in engine or just a tired motor