answersLogoWhite

0

Should be a 50/50 mixture of water and a good quality antifreeze You can purchase a premix

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

Engine diagram for 2000 Jeep Cherokee?

facing engine 2000 jeep cherokee the cap at 11 o'clock is that for coolant? like pre stone? the cap at 1 o'clock is that for brake fluid? where is the cap for transmission fluid?


What is coming out of the dash board panels that stinks and fogs up your windshield of your 2000 jeep grand Cherokee what is it?

Probably engine coolant. The heater core is leaking coolant.


Why is the coolant in your 2000 Jeep Cherokee rusty?

It is old and needs flushed and replaced.


How much engine coolant does a 2000 Toyota Corolla hold?

how much engine coolant dosee a 2000 toyota corolla hold


What kind of coolant is used in a 2000 Yukon?

The 2000 GMC Yukon typically uses a mixture of dex-cool antifreeze, which is an orange-colored coolant. It is a long-life coolant formulated for use in GM vehicles and provides protection against corrosion and helps maintain engine temperature. Always check the owner's manual for specific recommendations and ensure to use the proper mixture of coolant and water if diluting.


2000 jeep Cherokee Trouble Code 118 -Engine Coolant Temperature Sensor input above maximum acceptable voltage What causes this and how do you fix it?

replace the sensor.


How do you add engine coolant to a 2000 Lexus LS400?

To add engine coolant to a 2000 Lexus LS400, first ensure the engine is cool and locate the coolant reservoir, typically found near the radiator. Open the reservoir cap carefully to avoid any hot steam. Pour the appropriate coolant mixture (usually a 50/50 blend of coolant and distilled water) into the reservoir until it reaches the "full" line. Replace the cap securely and check for any leaks before starting the engine.


Why would a 2000 Honda civic si overheat?

lack of coolant . no cooling fan operation, low engine oil, improper coolant mixture, thermostat stuck, debri on radiator , restriction in cooling system.


Can you show a diagram of how a heater works 2000 jeep Cherokee?

I can't create diagrams, but I can explain how a heater works in a 2000 Jeep Cherokee. The heater system uses engine coolant, which is warmed by the engine. This coolant circulates through the heater core, a small radiator located inside the dashboard. A blower fan then pushes air over the heater core, warming it before it enters the cabin, providing heat to the interior of the vehicle.


Where do I add coolant to my 2000 Polaris sportsman?

To add coolant to your 2000 Polaris Sportsman, locate the radiator cap, which is usually found near the front of the engine compartment. Ensure the engine is cool before opening the cap to avoid burns. Add the appropriate coolant mixture until it reaches the recommended level, then securely replace the cap. Always consult your owner’s manual for specific instructions and coolant specifications.


Where to put water and coolant Into a 2000 BMW X5?

The water and coolant is put in the coolant reservoir for the location of this refer to the owners manual. It is best to do this when the engine is cold otherwise you run the risk of getting boiling water all over you. the mixture of coolant to water should be about 50/50.


How much coolant does the 2000 Oldsmobile alero 2.2 engine hold?

A 2000 Oldsmobile Alero with a 2.2 engine will hold approximately 13 liters of coolant. Adding coolant to your vehicle is very important.