0
You need electrical contact cleaner in a spray can. Flathead screwdriver and a Torx 15.
Locate the sensor on the drivers side just behind the air filter. There are 2 wire going into it.
Use the flathead screw driver and slide the red retainer clip straight back toward the drivers side fender. This is a clip to lock the plug connector in place. With the retainer clip slide back, use the flat head to gently pry the connector off the sensor. Then use the 15 Torx and remove the 2 screws . Slide out the sensor. Do not touch it !!! Spray the cleaner into the sensor and lit it dry. Reverse the instructions to re-install
What else can I help you with?
Where is the maf sensor on a 1990 ford f-150?
www.motorcraft.com doesn't list an air mass sensor ( MAF ) on the F150 until the 1994 model year
Where is the MAf sensor on a f150 4.2 v6?
Its located near your air filter box
Does a 2003 F150 have a MAP sensor?
www.motorcraft.com does not list a MAP sensor for the 4.2 L V6 , 4.6 L or 5.4 L V8 engines for a 2003 F150 , they list an air mass sensor which I assume is the MAF sensor
How do you clean the MAF sensor on 1996 ford explorer?
To clean the MAF sensor on a 1996 Ford Explorer, first disconnect the negative battery terminal and locate the MAF sensor, which is typically found between the air filter and the throttle body. Carefully remove the sensor connector and unscrew the sensor from the air duct. Use a specialized MAF sensor cleaner spray to gently clean the sensor wires or plate; avoid touching them directly. Allow it to dry completely before reassembling and reconnecting the battery.
Where is the mass air flow sensor on a 2005 Chrysler 300 2.7 v6?
It does not have a maf sensor.
What does the trouble code System too Lean Bank 1 mean for a 1999 Ford F150?
check the maf sensor
1995 Lumina is losing power?
First item to check is the MAF sensor. Buy cleaner from NAPA like CRC MAF cleaner. Follow the directions to clean the sensor.
Where is the mass airflow sensor located on a 2005 dodge ram 1500 3.7 V6?
It does not have a maf sensor.
How do you clean MAF sensor in Cadillac CTS?
To clean the Mass Air Flow (MAF) sensor in a Cadillac CTS, first ensure the engine is off and disconnect the negative battery terminal. Remove the MAF sensor from the air intake duct, being careful not to damage it. Use a specialized MAF sensor cleaner spray to gently spray the sensor elements, allowing it to dry completely before reinstallation. Reconnect the sensor and the battery terminal, and start the engine to ensure proper function.
Where is the MAP sensor on a 2000 F150 with 5.4 V8?
there is no MAP, it has a MAF sensor ( mass air flow ) its in the big round plastic tube behind the air cleaner
What would cause a P0102 diagnostic reading on a 2003 ford f150 when you have already replaced the MAF Sensor?
Check all your grounds
What causes a 1990 3.1 liter engine to surge at an idle?
Clean the MAF sensor with CRC MAF cleaner, do not touch the sensor wires, you'll damage the unit and freah is ~ $175.00
