0
95 4cyl dohc what are the proper cam timing marks there is a dot and also two lines which one do you use for your markings for setting the timing on a ford probe?
the correct alighnment is at TDC marked on crankshaft pulley = groove in tail end of both cam,s vertical with the pulley dowels uppermost on both cam,s = no 1 lead on distributer firing. cam pulleys are universal inlet cam should use the I and respectivly the exaust will use EX to identify location of dowel locating slot used
What else can I help you with?
What is the timing setting for a 1988 Toyota Tercel?
The timing setting for a 1988 Toyota Tercel is the "3E" hole lines at the top. This setting is for a Tercel EZ 1500 engine.
What are the color of the runway markings and runway hold lines?
white runway markings and yellow runway hold lines
What are the color of the runway markings and the runway hold lines?
white runway markings and yellow runway hold lines
What are the color of the runaway markings and runway hold lines?
White runway markings and yellow runway hold lines
What are the color of the runaway markings and the runaway hold lines?
The runway markings vary. The hold lines are flashing amber.
What are the color of the runaway markings and runway holds lines?
White runway markings and yellow runway hold lines
What is horizontal markings?
Horizontal markings are markings (such as painted or etched lines) that are horizontal (or parallel to the ground).
What care the colors of the runway markings and runway hold lines?
Runway markings are white. Runway hold lines are yellow.
What are the color of the runway markings and runway holdlines?
White runway marking snd yellow runway hold lines.
What is marks?
Horizontal markings are markings (such as painted or etched lines) that are horizontal (or parallel to the ground).
What are markings of a giraffe?
lines of creative designs
How do you set the Timing on a 1990 Mazda 626?
The timing should be at 6 degrees for a non-turbo, with the distributor vacuum lines disconnected and plugged. It will be at 9 degrees for a turbo, with a test connector for idle setting grounded.
