0
Make sure all of the rod bearings are aligning properly. Sometimes a bearing will be slightly "canted" and it will rub against the crankshaft. Make sure the rods and pistons have the correct side forward.
As you reassemble make sure that each piston/rod combination is still moving somewhat freely. Turn the crank a few turns before going on to the next. Since the rings are not seated they will drag a little on the cylinder walls until the engine has run for a bit, but you should be able to take that into consideration.
What else can I help you with?
How do you solve difficult problems?
You may be asked how you solve difficult problems when you are being interviewed. This gives the interviewer an idea of the skills and experience you have to use in solving problems.
Which kind of problems are the most difficult to solve?
ill-structured problems
What problems could arise if some scientists measured in inches and others measured length in centimeters?
you lick yourelf
What problems could arise if some scientist measured length in inches and others measured in centimeters?
you lick yourelf
What problems could arise if some scientists measured length in inches and others measured in centimeters?
you lick yourelf
How does a mentally healthy individual face problems?
In a thoughtful, measured manner.
When TCP IP is installed as a component of Windows 2000 XP What else is installed?
A group of utility tools is also installed that can troubleshoot problems with TCP/IP. (6th Edition, - Page 928).
What is a disadvantage to using tables?
it is often difficult to solve complicated problems alone
What can be done to fix noise in water pipes - especially if it is due to air getting into them?
Check to see if your faucet has an aerator installed. I had similar problems which were solved after I installed one.
How much does it cost to have a sunroof installed?
it costs about 400 dollars if you have the right car and they can install it no problems.
Why might you have problems with a system in which you installed three know good rimms?
because they're bad
What problems could occur if some scientists measured objects by using SI units and other scientists measured objects by using other units?
No problems provided they state which units. Most scientists are capable of converting between units.
