0
What else can I help you with?
Why does the air condition switch goes off on a 2002 Chevy Malibu while air condition is running?
I don't know but my 2000 Malibu air conditioner switch cuts off and on as well when it is running. the usual culprit, is a bad ac switch, go to a salvage yard and try to find one for your car. because new one are expensive!!
Where is the map sensor 2000 Chevrolet Malibu 3.1l sfi ohv 6cyl?
map sensor 2000 malibu location
2000 Malibu flasher location?
the flasher and hazards are all in one . if flashers are bad check hazard switch on dash. remove trim plate and remove screw that holds flasher switch in.
Where is the fuel pump reset switch on a 2000 Chevy Malibu?
no reset
Where is the wiper relay in a 2000 Chevy Malibu?
The 2000 Chevrolet Malibu windshield wiper relay switch is located on the firewall in the engine compartment. The windshield wiper relay switch will be on the drivers side of the firewall.
Where is the ac clutch cycling pressure switch located on a 2000 Chevrolet Malibu?
It is on the acumulator.
Where is the thermo switch located 2000 Chevy malibo?
where is the gas fuse located in a malibu
How do you change out the hazard switch in 2000 Malibu?
remove the trim around switch, remove screws that hold switch in, pull switch out, remove wire connector.
What size socket fits the front hub nut on 2005 Malibu?
how do you replace front passenger window switch on a 2000 chev malibu
Location of oil sending switch on 2000 Ford F150?
I am looking for the location of the oil sending switch on a 2000 F150, or where I can see a diagram or picture of it. Thank You
Location of smog pump on 2000 Malibu?
Smog pumps have not been used for at least 20 years, as far I can recall. My 2000 Malibu does not have one. Better engine controls through electronics have allowed for this.
How To Install Replace Hazard Switch 2000-05 Chevy Malibu?
To replace the hazard switch in a 2000-2005 Chevy Malibu, first disconnect the negative battery cable to ensure safety. Remove the dashboard panel using a screwdriver to access the switch. Unplug the old hazard switch from its connector, then plug in the new switch and secure it in place. Finally, reattach the dashboard panel and reconnect the battery cable.
