Yes the frames are the same. A 2-wheel drive frame is different then the 4-wheel drives.
YES IT CAN BE DONE BUT YOU HAVE TO HAVE A ETHER A 4WD BLAZER OR S10 THE FRAME IS 2 PEICES WELDED TO GATHER THERE ARE 2 DIFFIRNT FRONT FRAME HALFS 4WD AND 2WD JUST SAPARATE THE TO HALFS AND PUT THE 4WD HALF ON YOUR FRAME AND THEN SWITCH THE REAR END FROM THE 4WD TO THE 2WD AND YOU HAVE A 4WD
Nope it is 4WD you can change the settings to 4WD & 2WD
No. The 2wd and 4wd trans cases are compleatly different.
If same engine, and same 2wd/4wd, then yes.If same engine, and same 2wd/4wd, then yes.
I believe c= 2wd k= 4wd I believe c= 2wd k= 4wd
It was available either way.
c=2wd k=4wd
sure it will fit, as long as they are the same type, th350 or th400. also 2wd 0r 4wd.
Assuming that they are both 4wd or both 2wd and the same model transmission (4L60E), they are interchangeable.
The C2500 is 2wd and k2500 is 4wd.
The dashboard switch to the lower right side of the stearing column. If it's not there then you do not have 4WD.
they would be the same if both vehicles have same differentials . note that front and rear diffs on 4x4, must be matching ratio, to work properly when in 4x4