of course.
Mine did the same, mine was a motor mount.
Yes you can 351 and a 302 are pretty much the same engine block. the motor mount will work.
Front of the engine, behind the motor mount.Front of the engine, behind the motor mount.
An engine mount holds an engine in place. It can also be called a motor mount if a motor is specifically referenced.
The year, make, model and engine wasn't mentioned but in general you remove the motor mount anchor bolt(s), lift the engine a few inches and support it safely, unbolt motor mount(s) from engine, remove mount(s), replace mount(s) and finish in reverse order.
Front center of the engine, behind the motor mount bracket.Front center of the engine, behind the motor mount bracket.
Driver side of the engine, behind the motor mount.Driver side of the engine, behind the motor mount.
To replace the motor mount on a 1991 Volvo 240, first ensure the vehicle is securely lifted and supported on jack stands. Remove the old motor mount by unbolting it from the engine and the chassis, then carefully lift the engine slightly using a hoist or jack with a block of wood to access the mount. Install the new motor mount in the same position, securing it with bolts, and then lower the engine back into place. Finally, double-check all connections and ensure the mount is properly aligned.
It is on the front of the engine, kind of behind the motor mount.It is on the front of the engine, kind of behind the motor mount.
how to change a motor mount on a kia optima
Nope.
A loose engine mount would not normally cause the engine to fall out because each car has several motor mounts. A loose mount could cause the motor to be off of balance.