yes. easy fix. http://the-hush.com/ this part makes repairing studs much easier. no redrilling or retapping of bolts.
A broken piston ring is the most common cause of water in the exhaust manifold. A bad valve in the cylinder head can also cause the problem.
Exhaust manifolds get very hot, it is possible but not a common occurance
It carries the exhaust away from each cylinder and routes it to the exhaust pipe where it flows to the catalytic converter and then to the muffler where the sound is deadened. It then flows from the muffler to the tailpipe where it is released into the atmosphere.
Yes, the studs break off of the head at the ends of the manifold.
Yes, a 2002 Saturn SC is equipped with a manifold catalytic converter. In this type of design, the catalytic converter is integrated into the exhaust manifold, which helps to reduce emissions more efficiently by allowing the exhaust gases to be treated immediately after leaving the engine. This setup is common in many vehicles to save space and improve performance.
The 2004 Mercury Sable typically has two catalytic converters. One is located in the exhaust manifold, and the other is part of the mid-pipe section of the exhaust system. This dual setup is common in vehicles with V6 engines to help meet emissions regulations. Always consult the vehicle's service manual for specific details regarding your model.
Need to check the intake manifold, It is a common problem on the voretec engines.
Since they are really the same thing, there is no answer. An exhaust manifold is a header and vice/versa.The common cast iron 'exhaust manifolds' are quiet, last forever, and cheap to produce. The headers you refer to are more expensive, short-lived and can be very pricey. But the first guy who bolted a pipe on the exhaust post of his single cylinder motor to keep from getting burned by the exhaust created the first header. He also created the first exhaust manifold. Take your pick.
Two main kinds: true backfire is when flame leaps out of the intake manifold ... usually when trying to start the car. The more common form is when a air/fuel mixture builds up in the exhaust system and ignites. Often caused by a single cylinder not firing every time (or not at all).
I am assuming you are referring to port valves. Exhaust and intake valves are the most common names.
Milky appearance and texture of engine oil, white smoke from exhaust, overheating. Gaskets are a common problem with the 90 degree GM engines, so you're probably on the right track, although the intake manifold gasket is just as likely a culprit.
Yes I do