0
They should be metric,bolts with numbers on them 8.8,9.8 ect.There could be a few SAE bolts on the engine depending on your engine type.If there are no numbers on them,and have short slashes they are SAE.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Removing difficult starter bolts on 1997 Ford Taurus?
If the starter bolts are difficult to remove on a 1997 Ford Taurus, they were probably put on using an air wrench. An air wrench can be used to remove them or a product called Liquid Wrench.
Are the brake lines on a 1997 wrangler metric?
No, they're standard measurements
What wrench do you use to remove caliper mounting bolts from 1997 Ford Taurus front brake?
You need 15 and 18 mm wrench.
How do you change the ignition coils on a 1997 Ford Taurus SHO?
Looks like they just unbolt by two bolts and go over the spark plug.
Where is the shift module on a 1997 Ford Taurus?
were is the shift module on a 1997 Ford Taurus
What is the lug spacing on a 1997 mercury mountaineer?
5x114.3 Think it will work with 5x4.5 too (standard/metric conversion) but not sure.
What is wiper blade size of 1997 Ford Taurus?
there it is http://mywiperblades.com/1997-ford-taurus-wipers.htm
Where is the ingition module located in 1997 ford Taurus?
It is on the left side, about half way down the steering column. It has two bolts holding it in and one holding the wiring harness on it.
Where is the radiator cap on 1997 Taurus?
On a 1997 Ford Taurus the thread on cap on the engine coolant reservoir is the pressure cap / radiator cap
What is the size of lug nuts and are they metric or standard on a 1997 Toyota Camry?
They are standard SAE threads. The way to find the size is to try different sockets. Most are 3/4" but they may be 5/8".
How do you remove an oil pump from a 96 Taurus?
there is no oil pressure in my 1997 ford taurus, but the oil is full?
Will a 1997 Ford Taurus transmission fit in a 1996 Ford Taurus?
as long as you have an the sAME TRANSMISSIONS THEY WILL BE INTGERCHANGABLE.
