answersLogoWhite

0

The throttle position sensor is on the back of the carberator. Held in with two star bolts. Unscrew them and put your new sensor into place. Note the position of the old sensor. very tight space. little room to work. but its managable without removing any other parts.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

How do you install a throttle position sensor on a 99 F150?

Disconnect the battery. On the side of the throttle body, disconnect the wiring from the position sensor. Remove the bolts from the sensor, and lift the sensor off, reverse the procedure to install the new one.


How do you change throttle position sensor on cadillac 2003 cts?

To change the throttle position sensor on a 2003 Cadillac CTS, first disconnect the negative battery cable to ensure safety. Remove the air intake duct to access the throttle body, then detach the electrical connector from the throttle position sensor. Unscrew the sensor from the throttle body, replace it with the new sensor, and reassemble everything in reverse order. Finally, reconnect the battery and perform any necessary throttle relearning procedures as recommended by the manufacturer.


Installing 2001 Buick Century throttle position sensor?

How to install tps


How do you install a throttle position sensor on a 1998 mercury villager?

remove and reinstall


How do you replace the throttle position sensor in a 98 Olds intrigue?

The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.


Where is the throttle position sensor located in a 99 Cadillac catera?

It is built in the throttle body assembly the tps you see on line is not correct


Where is the throttle position sensor in a 2005 Chevrolet Cobalt?

The throttle position sensor is in the throttle body.


How do you check the throttle sensor on a Cadillac Fleetwood?

To check the throttle sensor on a Cadillac Fleetwood, first ensure the vehicle is turned off and disconnect the battery. Next, locate the throttle position sensor (TPS) on the throttle body and use a multimeter to measure the voltage at the sensor's electrical connector while moving the throttle plate. The voltage should change smoothly as the throttle opens and closes. If the readings are inconsistent or out of the specified range, the sensor may need to be replaced.


What is the fuction of a throttle position sensor?

The function of a throttle position sensor is to monitor the position of the throttle in an internal combustion engine.


Where is the location of throttle position sensor for Cadillac DTS 2003?

The throttle position sensor (TPS) on a 2003 Cadillac DTS is located on the throttle body, which is situated on the intake manifold. The sensor is typically mounted directly on the throttle body assembly and is connected to the accelerator pedal mechanism. To access it, you may need to remove certain components for better visibility and space. Always refer to a service manual for specific instructions and diagrams.


Where is the throttle position sensor on 1999 Pontiac Montana?

The throttle position sensor is located on the throttle body at the end of the throttle shaft.


Where is the throttle position sensor located on a 1998 Chevrolet Camaro?

The throttle position sensor is located on the throttle plate.