0
I did a 2004 for my girl friend last month and had a similar problem. It ended up that the rubber dust/moister boot that is under the head of the bolt and goes to the lip on the caliper was torn allowing moisture to enter the bolt/pin was rusted solid. I could give you ten ways to try but let me just say this. Make sure you use a 6 point socket or wrench that fits snugly around the head. Most important is to get some penetrating oil on it and let it soak thoroughly. If you must use heat be awfully careful not to damage any parts or start a fire or blow yourself up. You can also try shocking the bolt with some hammer blows to the head.>!!! Do not damage the shape of the head or your wrench will not fit !!!< >Lastly Use Common Sense!<
What else can I help you with?
On a 2003 Pontiac Montana which caliper mount bolt has the rubber grommet the top or bottom?
Both the upper and lower caliper bolts must have the rubber boots on them. Otherwise, dirt and moisture will get in around the bolts and cause them to stick in the caliper mounts.
Where are the caliper bolts on a 2003 Ford F-250?
The caliper bolts are located in the caliper... You should see two bolts on the inside of the caliper...
Will factory tires and rims from a 2001 Pontiac grand am work properly on a 2003 Pontiac grand am?
The factory tires and rims from a 2001 Pontiac grand am cannot work properly on a 2003 Pontiac grand am.
Will factory rims and tires from a 2001 Pontiac grand am fit on a 2003 Pontiac grand am?
Rims and tires from a 2001 Pontiac Grand Am will fit on a 2003 Pontiac Grand Am. They have the same lug nut pattern.
Where are the freeze plugs located on your 2003 Pontiac grand am gt?
Where are the freeze plugs on a 2003 pontiac grand am
Does a 1995 Pontiac Grand Am wheel fit on a 2003 Pontiac Grand Am?
yes...
Where is the windshield washer pump in a 2003 Pontiac Grand Am?
How do you change the windshield washer pump on a 2003 Pontiac Grand Am
What is the torque spec for front brake caliper bolts on a 2003 Suzuki Grand Vitara?
The torque specification for the front brake caliper bolts on a 2003 Suzuki Grand Vitara is typically around 20-25 ft-lbs (27-34 Nm). It's essential to consult the vehicle's service manual for the exact specifications and to ensure proper installation. Always use a calibrated torque wrench for accuracy when tightening the bolts.
How do you fix a clock radio light in a 2003 Pontiac grand am?
how to fix the light for the clock radio in a 2003 Pontiac grand am
Will a headlight from a 1999 Pontiac Grand Prix fit a 2003 Pontiac Grand Prix?
yes
How do you change the front brakes on a Pontiac Grand Prix 2003?
Remove wheels Re-install 2 lug nuts to hold rotor in place Remove 2 caliper mounting bolts Slide caliper off rotor Fully retract piston into caliper body using a "C" clamp Replace inner and outer pads Re-install caliper on to rotor PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
How do you change the brake pads on a 2003 Pontiac Aztek?
To change the brake pads on a 2003 Pontiac Aztek, start by lifting the vehicle and removing the wheel. Next, remove the caliper bolts and carefully slide the caliper off the rotor, then remove the old brake pads. Install the new pads, ensuring they are properly aligned, and reattach the caliper. Finally, replace the wheel, lower the vehicle, and pump the brake pedal to ensure the pads seat correctly.
