no it has to be reprogramed by dealer
To reset the computer on a 2002 Ford Taurus disconnect the negative battery cable. Leave the battery cable disconnected for five to ten minutes. Reconnect the cable and start the car. The computer should be reset.
To reset the alarm system on a 2003 Ford Taurus, first, ensure that the car battery is fully charged. Next, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes, which should reset the alarm system. Finally, turn the ignition off, remove the key, and then try starting the car again. If the alarm still activates, consult the owner's manual or consider seeking professional assistance.
how to reset anti-theft system to start engine
how to reset hornet alarm,, cause my car can't start..alarm still active,,
It really needs to be diagnoised since it can be a wire or the ignition switch itself.
The system will need to be reset or repaired. To reset a original GM system start by using the remote lock and unlock the doors. Then have a repair shop scan the computer and see if it can be reset. If that does not work it will need to see a GM dealer or qualified repair person.
If you try to start the car it should start then turn off by itself, just leave the key in the run position and the "Theft System" light on the dash will be flashing. Leave the key on for about 10 minutes and the light will stop flashing and go on solid, then the theft system is disabled.
You can't bypass or reset security system, bring it to the dealer.
wait 10 minutes for the passlock system to reset for a GM vehicle.
Contact the dealer.
If the car has a hard bang such as a cd Joint coming apart it may shut off the fuel system. The switch is on the passenger kick panel near the floor . It has a small door with a reset button.
To reset the AC system in a 2004 SL500, start by turning off the vehicle and disconnecting the battery for about 10 minutes to allow the system to reset. Reconnect the battery, then start the car and turn on the AC. Adjust the temperature and fan settings to see if the system operates correctly. If issues persist, it may be necessary to consult a professional or check for any fault codes.