the answer is yes and no if the washer fuse is blown then that would be the first thing to check in that circut, and no the chech engine light only comes on when computer monitered circuits are involved not accessories such as windshield washers you will need to scan the cars ecm in order to pinpoint what controled circut is out of parameters
If washer fuse is blown replace it first ,still washer not working ? One can check motor by following method unplug motor from Engine wiring and connect to separate 12VDC supply from Engine Battery if it does not moved throw & get new one. Maxmagic
It's located near the bottom on the side of the washer fluid reservoir. It's a little cylinder and it's got a cable running to it and a rubber washer fluid hose running out of it.
Check for 12 volts at the washer pump connector before all else. If you have 12 volts when the button is being pushed (with the key in the on position) your pump is the problem.
The fuse location is underneath the drivers side on the dashboard. It is the second fuse from the bottom on the left side in the fuse box.
The fuse for the windshield washer pump on a 1995 Toyota Corolla is located in the fuse box under the dashboard on the driver's side. Specifically, it is typically a 15-amp fuse labeled "WIPER" or "WASHER." To access it, you may need to remove the fuse box cover and check the diagram on the cover for the exact location. If the fuse is blown, replacing it should restore function to the windshield washer pump.
To replace the windshield washer pump on a 1995 Toyota Corolla, start by disconnecting the negative battery terminal for safety. Remove the washer fluid reservoir by unscrewing any bolts and disconnecting the fluid lines, then locate the pump at the bottom of the reservoir. Detach the electrical connector and pull out the old pump, then insert the new one and reconnect the electrical connector and fluid lines. Finally, reassemble the reservoir, refill it with washer fluid, and reconnect the battery before testing the new pump.
Yes, and it's the same fuse that's used for your wipers. So, if your wipers still work, but the washer fluid pump doesn't, there's likely a problem with the pump and not the fuse.
There are three fuse boxes on a 1999 Toyota Corolla. One is located behind the steering wheel, and the other two are located in front of the windshield washer fluid reservoir and then next to the battery. The wiper fuse is number 4, in the Instrument Panel Junction Block on the Front Side of the vehicle.
how to replace the washer pump on a 2009 toyota camry
It is attached to the lower front side of the windshield wash reservoir (front left-when looking under the hood) by grommet/nipple pressure connection.
A common probem with the 93 is a broken retaining clip and it slips around in the engine compartement. Use 18 guage wire, wrap one end around one of the holding bolts, run it around the container, and tie it to the other bolt.
How difficult is it to replace a 2000 Toyota Avalon window washer pump and where is it located?