0
Can i flat tow a 1989 ford bronco2 4x4 automatic trans without disconecting the driveshaft?
Flat towing a 1989 Ford Bronco II 4x4 with an automatic transmission is not recommended without disconnecting the driveshaft. Doing so can cause damage to the transmission due to lack of lubrication while being towed. For safe flat towing, it's best to either disconnect the driveshaft or use a tow dolly to ensure the vehicle's drivetrain is not compromised. Always consult the owner's manual for specific towing guidelines.
What else can I help you with?
Can you charge battery without disconecting?
Yes, you sure can.
Can you drive a Jeep Cherokee without the rear driveshaft?
No.
Can a 94 jeep wrangler be driven without a front driveshaft?
Yes
What is usually regarded as the absolute maximum length a driveshaft should be without adding a center support bearing?
70 inches is usually regarded as the absolute maximum length a driveshaft should be without adding a center support bearing
Can you tow dolly a dodge Dakota without dropping drive shaft?
2wd with automatic transmission and rear wheels dollied, yes.2wd with automatic transmission and front wheels dollied, no.2wd with manual transmission in neutral, front or rear wheels dollied, yes.4x4 with automatic transmission, no, you must drop the driveshaft of whichever wheels aren't dollied.4X4 with manual transmission in neutral, best to dolly the front, but the rear can be dollied as well (make sure the transmission and the 4wd switch are both in neutral).Bottom line: No matter the vehicle, the safest way to tow, bar none, is to drop the driveshaft to the wheels on the ground.
What kind of welder do you use on cars?
Any kind you want. Ihave used welders many times without the recomendation of disconecting the body and engine computers without any problems. However you should disconnect them to be safe before welding.
Can a dishwashing detergent without phospate be used in a automatic dishwasher without damage?
can a dishwashing detergent without phospate be used in an automatic dishwasher with damage
What do you have to do to dinghy tow your 2004 2 wheel drive trailblazer behind your motor home?
Remove the driveshaft. There were no manual transmission Trailblazers, so flat towing without removing the driveshaft really isn't an option.
How do you tow a 1996 z71 Chevrolet with tow truck?
Couple ways to go about it. Put the transfer case in neutral (or the transmission, if a manual), and you can tow it from either axle. If it has an electronic transfer case without a switch to go into neutral and an automatic transmission, you'd have to separate the driveshaft from the axle remaining on the ground.
Will it run without a transfer case on a 1993 Chevy 2500 4x4?
NO. There's no way to hook the driveshaft to the transmission.
Can you flat tow a two wheel drive ford ranger with an automatic transmission?
You can but should pull the driveshaft. Without the engine running, pump is not running to the transmission & this will protect it. Just take off rear u joint (4 nuts) & pull backwards to remove. To reinstall, torque strap/nuts to 16#.
Can 94 Z28 6spd std transmission be towed behind MH without doing damage?
no you must take driveshaft loose and tie it up. but do not remove or you will loose all trans fluid. if driveshaft not unhooked trams damage will happen
