answersLogoWhite

0

Noisy lifters in 2.2 and 2.5 sohc engines are usually indicative of a worn camshaft, as many were replaced under warranty.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How long is the oil dip stick in a 1988 Plymouth reliant?

About 18 inches


How do you install a camshaft seal in a 1988 Plymouth reliant 2.5l?

youtube that sh*t bro haha


Where is the power brake reservoir on a 1988 Plymouth Reliant?

Under the hood on the upper firewall on the driver's side


What is the gas tank capacity of a 1988 Plymouth reliant?

The gas tank capacity of a 1988 Plymouth Reliant is approximately 14.5 gallons. This model was designed to be economical, reflecting the compact car trends of the late 1980s. Its fuel efficiency, combined with the tank size, contributed to its practicality for daily driving.


Where is the oxygen sensor located on a 1988 Plymouth reliant?

There are two. They are in the exhaust system. One is before and one is after the catalytic converter.


Will a 1988 dodge mini ram van cvc fit a 1983 Plymouth reliant?

no it wont cause the engine mountings are different


Where is the starter on a 1988 Plymouth reliant k?

It is on the back of the engine, under the intake.It is on the back of the engine, under the intake.


Where is the power steering reservoir on an 1988 Plymouth reliant?

The power steering pump is by the firewall on pasanger side of car. Fill it with transmission fluid. The cap has a dipstick on it.


Are 1983 Plymouth reliant k car taillight lens compatible with 1988 k cars?

They looked similar but they were in fact a bit different from each other, and as such not interchangeable.


Where is the knock sensor on a 1988 Plymouth reliant?

On a 1988 Plymouth Reliant, the knock sensor is typically located on the engine block, near the cylinder head. It is usually found on the lower part of the engine, often on the driver's side. To access it, you may need to remove certain components for better visibility. If you're having trouble locating it, consulting a repair manual or a service guide for the specific engine type can be helpful.


How do you replace speedometer cable on 1988 Plymouth reliant le?

To replace the speedometer cable on a 1988 Plymouth Reliant LE, first, disconnect the negative battery terminal for safety. Remove the instrument cluster by unscrewing the bolts and carefully pulling it out. Detach the old speedometer cable from the back of the cluster and the transmission, then install the new cable by reversing the process, ensuring it is securely connected at both ends. Reassemble the dashboard and reconnect the battery to complete the installation.


Where is the fuel fuse for a 1988 Plymouth reliant?

Fuses are located on the left hand side of the steering column, you need a phillip's (cross) head screwdriver #2 the panel saddle's the steering column.