== ==
P0601 : internal controller processor failureThe engine computer will need replaced.P0601 : internal controller processor failureThe engine computer will need replaced.
Is it a wired controller? Is it possible that there's a short in the wire. Wiggle the wire around a bit. At any point does the controller work again (even briefly)? If so, there's a short and the controller needs to be replaced. If it's a wireless controller, make sure the batteries are fresh. If so, there could be a signal problem.
Most controllers are replaced when no longer working and not fixed when broken. It is already a used controller and the cost to replace with another used controller is less than the time and labor spent to discover the problem and repair it.
Zara Asker, a former mission controller
if your Logitech precision controller for a PS3 has stopped working you will need to return the controller to the store.
To test the glow plug controller on a 6.5L diesel engine, begin by ensuring the engine is off and the ignition is in the "off" position. Use a multimeter to check for voltage at the glow plug controller terminals while turning the ignition key to the "on" position; you should see voltage indicating the controller is functioning. Additionally, inspect the controller for any visible signs of damage or corrosion. If the voltage is absent or the controller appears faulty, it may need to be replaced.
PS2 controllers break and can be replaced. The market is loaded with used working PS2 controllers that should be purchased if your controller is not working perfect.
Zara Asker, who was a mission controller before being the chairwoman.
Broken controllers should be replaced. If you connect your charging cable to the PS3 USB and the controller and it still will not work buy a new one. You should have more than one anyway
A method that has worked on some cell phones that have gotten wet is to put them in a bag of rice to absorb the water. Sometimes it works. Water and electronic devices do not get along well together and often the item must be replaced.
The PS# controller may need to be synced again. If not, it may need to be replaced.
The temperature controller in your Ford vehicle controls the heat and air conditioning. You can check them by following the steps: 1) Open the fuse panel under the steering column and locate the fuse for the temperature controller. Use the fuse diagram to locate the temperature controller fuse and pull the temperature controller fuse using the fuse pullers in the fuse box. 2) Check the metal strip inside the fuse to make sure that it is not broken or burned. If it is burned or broken, you will need to replace the fuse with a new fuse of the same amperage. 3) Turn on the temperature controller's power. If the temperature control module does not start, then there is a problem with the controller and it will need to be replaced by a professional mechanic. The most common cause for temperature control failure is a short in the temperature controller's circuit board.