No, use only ATF+4
No, use only ATF+4
Mopar ATF+4
To service the transmission on a 1997 Chrysler Cirrus, start by checking the transmission fluid level and condition; if it's low or dirty, replace it. Drain the old fluid using the transmission pan drain plug, and replace the transmission filter and gasket. Refill with the appropriate type and amount of transmission fluid, then take the vehicle for a short drive and recheck the fluid level. Ensure to check for leaks and perform any necessary adjustments to the linkage or settings if needed.
It is on the front of the transmission, below the cooler hoses.
was wondering if someone can tell me how in detail to remove the tranny from my 1997 chrysler cirrus i need to replace the torque converter seal
YesYes
You add transmission fluid down the dipstick tube.
You pour the transmission fluid down the dipstick tube.
It is the two wire sensor on the front, far driver side of the transmission.
antifreeze leak
May have to drop the transmission oil pan to change fluid and filter May have to drop the transmission oil pan to change fluid and filter
ATF +4
Rear head, closest to the transmission.Rear head, closest to the transmission.