answersLogoWhite

0

What else can I help you with?

Related Questions

Remove brake light on a 2005 chev aveo?

remove the power chip or disconnect the battery and then disconnect it manually!!


How do you reset the check engine light on a Chevy Aveo?

There are many reasons for that check engine light. You could go to dealership. Or you could simply disconnect battery and reconnect after 3 minutes.


How many gallons is in a Chevy aveo gas tank?

2008 Chevy Aveo hold 11 US gallons.


What does the warning light HOLD mean on a 2009 Chevy aveo?

The hold light refers to the hold button on the shifter module. It means the transmission holds the lower gear revving up the rpms and won't shift to the higher gear. Seeing the light means the button has been engaged. Push it to turn it off


How many quarts of oil does 2006 aveo hold?

4qts


How much gas can a Chevy Aveo hold?

12 Gallons


How many gallons of gas does it hold on the 07 Aveo?

10 gallons


How do you replace the side light on a Chevy aveo?

To replace the side light on a Chevy Aveo, first, ensure the vehicle is turned off and the keys are removed. Locate the side light assembly, which is usually accessible from the wheel well or by removing the inner fender liner. Disconnect the wiring harness, twist the socket counterclockwise to remove it, and then replace the old bulb with a new one, ensuring it is securely seated. Reassemble the light assembly, reconnect the wiring, and test the new light before driving.


How do you take ignition off steering column of a 2005 Chevy aveo?

To remove the ignition switch from the steering column of a 2005 Chevy Aveo, first disconnect the negative battery cable to prevent any electrical issues. Then, remove the plastic covers from the steering column by unscrewing the screws that hold them in place. Next, locate the ignition switch, disconnect the wiring harness, and remove the screws securing the switch. Finally, carefully pull the ignition switch out of the column.


What does it mean whenFlashing hold light in Chevy aveo?

A steady on "Hold light" means you pressed the hold button next to the shift lever, repress to disengage. A flashing "hold light", usually accompanied by the flashing check engine light means the car is in limp mode. Limp mode stops the transmission from switching to forth gear and engages at 35 mph. Check the Manifold Absolute Pressure sensor wiring, should have 5volts between the outer two wires with ignition turned on and the middle wire to outside wire voltage should change 1-5volts when you start the vehicle, also check the vacuum line for cracks. Check the Throttle Position Sensor connector. If both are good remove the plastic cover from the top of the engine and you will see the Camshaft Position Sensor between the camshafts on a 2005 or earlier Aveo disconnect the plug check the ohm reading between the pins it should be between 460-620 ohms. If none of the above finds the problem then it probably needs a relearn procedure on the cam position sensor, this can only be done at a dealership. Disconnectinng the battery for 15 mins usually resets aveo service lights if the problem is still there the flashing hold light will come back on.


On a Chevy Aveo How much gas does the tank hold?

I have a 2005 and it holds about 12 gallons.


How much fuel does a 2006 aveo hold?

Practically speaking, my 2006 LT holds about 12 gallons. This page says it's 11.9. http://www.motortrend.com/cars/2006/chevrolet/aveo/specifications/index.html