0
What else can I help you with?
Does a 98 Park Avenue have a factory amp and if so where is it located?
The amp is located in the trunk just below the rear window on the left side.
Where is the 1993 Park Avenue factory amp and Where is it located?
The 1993 Park Avenue factory amp, also known as the factory amplifier for the 1993 Buick Park Avenue, is typically located in the trunk of the vehicle. Specifically, it is often mounted on the driver's side, behind the trim panel. This location helps in providing power and sound amplification for the vehicle's audio system.
What is the fuse schematic for a 1992 Buick Park Avenue?
my radio blows fuses for no apparent reason--i thought it was a short in the steering column, but driving straight today it blew again---i need to know if it takes a 10 or 20 amp fuse---please help if you can (1993 park avenue)
When hooking up an amp and speakers do you wire the speakers through the stereo or the amp?
Hook your speakers up to the amp.
Can you hook up sub woofers to the stock stereo in 1997 s10 blazer?
yes, you have to go to your local stereo dealer and get a line converter. that will convert the regular speaker wires to rca which is the preferred way to hook up an amp
Where is the self leveling fuse located on a 1991 buick park avenue diagram?
20 amp fuse number 12, fuse pannel located by driver's left knee.
How do you hook up a stereo equalizer?
Put the E.Q. between the pre amp and the main amp.
Your amp cuts off when you hook it up to your subwoofers?
either your amp has a short..... or.... you have a bad ground
Where is the fuse for the windshield washer pump located on a 1997 Buick Park Avenue?
Location of this is tricky. Look under the right hand of the instrument panel. near the rear of ihe instrument panel compartment. Under the glove box. Hope you can find it it's hard to see. It also has a cover. The fuses to check are marked as wsw/rfa 10 Amp and wsw 25 or 30 amp. Happy hunting.
How do i wire a toggle switch for an amp?
Hook a switch up to the remote turn on and ground. Before the wiring for the amp.
How do you hook up an vr3 200 watt 2 channel amp to a car stereo?
well you hook it up
Can you hook a car subwoofer to a DJ amp?
Yes you can hook up a car subwoofer to a dj amp. Some dj amps have a barewire hook up on them so you can hook it up using the same wires as you would with your car amp. If not then you would have to either convert your hook up on the speaker box to the style in which your amp takes, or splice new ends onto your existing wires to hook up to the amp. The one thing to watch out for is your rms and peak power. Dj amps tend to be a bit more powerful then car amps and you can cause damage to your speaker and or amp by forcing to much power, or by giving to little power. I suggest trying it out at home for a good amount of time on a med. power level to see if the amp and speaker can hold to a couple hours of non stop use before I would take it to a gig with me.
