answersLogoWhite

0

NO - all bolts are needed, (that's why they tapped holes for them )

User Avatar

Wiki User

12y ago

What else can I help you with?

Related Questions

How do you get to the last 13mm bolt on a water pump without removing the whole power steering pump on a 3.8l 98 Buick Regal?

Remove the power steering pump. I just did a water pump. If you remove the top PS pump bolt and loosten the lower PS pump bolt about 1/2 way you can push the pump over with one hand while removing the water pump bolt.


Can the water pump housing gasket on a 2point4 Liter 1996 Pontiac Grand Am be replace without removing all the parts that are required to be removed when replacing the pump itself?

no it cant i just finished my water pump install on my 2.4L and you have to un bolt the header pipe sorry!


How do you take out a broken bolt out of a 1993 dodge caravan water pump?

You will need to drill the broken bolt out and install a heli-coil thread repair.


What is the Water pump bolt torque on Chevy Trailblazer?

The torque of a water pump bolt can be requested from the manufacturer. The Chevy Trailblazer has a high torque for the water pump bolt.


How do you change a water pump on an Audi 80 v6 avant?

Drain the radiator. Remove the pump belt, fan, and fan shroud. Unbolt the pump then remove it. Bolt the new pump on, and install the fan an shroud. Put the belt on and refill the radiator with fresh coolant.


How do you install a water pump on a 2004 axiom?

how do you install a water pump on a2004 Isuzu axiom


What size of bolt goes in the water pump of a 83 yz80?

which bolt


How do you replace a water pump in 1992?

how do you install a water pump on a 1992 toyota camry


How do you replace the water pump on a 1998 GMC Sonoma sls?

the water pump on the 4.3L vortec is easy. there are four bolt holding the water pump in place. these bolt hold your fan clutch also. the water pump and fan system.are built as one. remove these bolts and you are ready to change your water pump.


How do you replace the water pump in a 2002 3.8L Impala The water pump is stuck with all the bolts out how do i get the water pump off?

The steering pump is attached with 2 bolts. If you take the top bolt out and loosen the bottom bolt until it's almost completely out, you can move the pump/pulley enough to snake that bottom left water pump bolt out.


How can I install a recirculating pump in my home?

To install a recirculating pump in your home, follow these steps: Turn off the water supply to your home. Identify a suitable location near the water heater for the pump. Install the pump on the hot water line, following the manufacturer's instructions. Connect the pump to a power source. Install a check valve to prevent backflow. Turn on the water supply and test the pump to ensure proper operation.


How do i install water pump on 90 accord?

You first disconnect the battery, then drain the cooling system, discount belt from engine and water belt pulley, then remove the water pump bolts and remove the water pump, then you install the new water pump and put everything back.