answersLogoWhite

0

yes. you drain as much engine oil from them sump as you can by undoing the 13mm sump plug. you then undo all the bolts holding the sump onto the engine

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Can you remove a Ford Focus engine from above without a hoist?

If you use a tripod.


How can you replace the engine starter on your Ford Focus SVT?

Begin by removing the positive cable from your battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new Ford starter.


Can removing the catalytic converter on 06 focus ruin the engine?

It will really mess up the fuel mileage,and driveability


Does a Ford Focus 1.8tdi have a timing chain?

yes they do have a timing belt . u can check this by removing the cover on the end of the engine,hope this helps


How do you remove a thermostat from a 2004 Ford focus engine 2.3L?

remove the belt remove the 3-4 bolts on the steering pump remove the 3-4 bolts on the thermostat reinstall the same


How do you remove a 2003 ford focus ZX5 alternator?

remove the passenger side motormount, and eater reservoir. jack up the engine and pull out from the top of engine. you will need to get under the car to get to the back bolts...


How much is a 2002 ford focus without an engine is worth?

About 15 cents a pound at the scrap dealer.


How do you check the spark plugs in 2002 ford focus?

Remove plugs - visually inspect for condition - check gap (2 liter SPI engine: 1.3 mm or .051 inches) (2 liter Zetec engine: 1.4 mm or .054 inches) Ford recommends that if you are removing them for inspection only and intend to re-install them, that you re-install them in the same cylinder they were revmoved from. Since you've already gone to the trouble of removing them to check, you might just as well go ahead and replace them. (Part # for the Zetec engine: AZFS32FE - - - - for the SPI engine: AGSF34EE)


Ford Focus engine?

How do you turn of the engine on a new ford focus


How do your replace rear motor mount ford focus?

You need to put the car on jack-stands, remove the wheel and the splash pans, remove the bottom fastener, lift the engine and remove the mount, replace in reverse.


Where are the glow plugs on a Ford Focus 2.0TDCi situated and how do you replace them?

The glow plugs on a Ford Focus 2.0 TDCi are situated on top of the engine in a line. They are replaced by removing the plug wires and deep walled socket is used to unscrew the plugs.


What does concetrate mean?

Concentrate means to focus on something intently, giving it your full attention. It can also refer to a substance that has been made stronger by removing some of the other components through a process like evaporation or filtration.