no you can not , you need same code on transmission
You have to pull the engine.
The head gasket.
How to replace tranmission mount
unbolt it, yank it out, put new one in, bolt it.
Loosen the transmission mount retaining bolts. Loosen the back to engine retaining bolts. Jack the transmission of approximately 1 inch. Remove the transmission mount bolts. Remove the transmission mount. Reverse the process to install the new transmission mount.
You have to take the wheel off and the splash pans and go in from there. After you get the bolt(s) loose, you need to lift the engine to replace. Most use a tripod.
can i yous transmission ford focus
On a 2000 Ford Focus, the transmission control module (TCM) is typically located near the driver's side, often mounted on the transmission itself or near the engine compartment. To replace it, first disconnect the battery, then remove any necessary components for access, such as the air intake duct or battery tray. Next, unplug the wiring harness from the TCM, remove the mounting bolts, and replace it with the new module. Finally, reassemble everything and reconnect the battery.
I am not sure what the question is, the transmission model number for a 2005 Focus is a 4F27E
On a 2007 Ford Focus with a 5-speed manual transmission, the output speed sensor is located on the transmission's case, typically near the rear of the transmission assembly. It is positioned on the driver's side and can be accessed from underneath the vehicle. To replace or inspect it, you may need to remove any obstacles, such as the exhaust or heat shield, for better access.
Without knowing US or European version, Automatic or Manual, and year there is no way to answer this question other than: Support engine and transmission assembly, Unbolt failed component and bolt in new.
no