if it has a clutch, allow vehicle to roll downhill and "pop" the clutch or engage engine. That will start the engine
If your Ford Bantam is not starting, you might have a dead battery or a problem with the starter. You might also have an empty gas tank or clogged fuel filter.
The starter have a bad rep But you can replace the relay and clean the connections but 9 out of 10 times it's the starter itself.
The starter could be bad. Or the battery. The starter could be bad. Or the battery.
selonoid is bad on fire wall or switch wire on stater selonoid is bad
The F150 uses a safety switch on the clutch system. The switch is under the dash on the clutch pedal arms. If the switch is bad, then the engine will not start.
the starter or the battery could of gone bad.
That would be a bad fuel pump in that tank
Sure.
The starter or solenoid are most likely bad. The starter assembly can be removed and put on a starter tester to see if its bad.
the ground wire running from the starter solinoid to the starter sounds to be bad
If you have no battery then you have no power.
This sounds like your starter solenoid is bad.