answersLogoWhite

0

The licence plate lamps are replaced from the outside. Use a small, flat blade screwdriver and gently pry up on the left side of the lamp housing. The flexible metal retaining clip is on the left side and the fixed plastic hooks or clips are on the right. Replace the lamp with a C5W or equivalent. Install the lamp housing in the reverse order by inserting the right side first, then pop in the left side.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you replace license plate light on 2006 Pontiac G6?

how do you replace license pate light on 2006 pontia g6


How do you change a license plate lamp in a 2006 Chevy Equinox?

how to change 2005 equinox license plate light i removed the screws but it didn't release


How do you clean throttle body and throttle plate 2006 Ford Focus?

no


License plate lights do not work?

i replaced the fuse on my 2006 chey colrado licence plate and it still doesnt work


Where is the trunk release in 2006 Nissan 300z?

it is above the license plate. it is a black button.


How do you change license plate bulb on a 2008 subaru legacy sedan?

The 2006 Legacy license plate bulb is accessed by removing the liner in the trunk and un screwing the plastic socket.


How do you install a front license plate holder on a 2006 4-door V6 Honda Accord?

Go to a Honda dealer and get a license plate bracket for that model/year. That's what I did for my 2006 Civic. It's held on by two screws on the bottom that go through two clips on the plastic grill just beneath the bumper. The top two screws just hold the license plate to the bracket. No need to drill holes in the bumper. Hope this helps.


Where is the engine block heater on your 2006 ford escape?

If equipped with one, it is right behind the license plate holder. It comes out from behind the front license plate, has a neat little cap & tucks back up behind the plate while driving, so it'll stay clean during the winter driving.


License plate bolt size for 2006 mazda3 hatchback?

Use metric 6 mm or 1/4 inch self tapping screw to attach plate. ( North America only )


How do you change a license plate bulb in a 2006 infiniti qx56?

let your dealership fix it. 4yr 60k mile warranty on those bulbs


Where is location of front license plate bracket on a 2006 volkswagon jetta?

Not all vehicles come from the factory withe the front plate bracket installed. If you don't easily see it, then you will have to buy one from the dealer.


What size screw is used for the rear license plate for a 2006 c280 Mercedes?

For a 2006 Mercedes C280, the rear license plate typically uses M6 x 1.0 screws. These screws are often either stainless steel or zinc-coated to resist corrosion. It's advisable to check the specific requirements in the vehicle's manual or with a dealer for exact specifications, as variations may occur.