Remove and dry inside rotor cap with hair dryer, look for crack on cap and most likely it does not have seal.
Try applying small amount of silicone to stop moisture in future.
Since there is very little detail given about the problem I can only give a generic answer. If your speedometer has also been "erratic" during high humidity and rainy days, the problem is most likely a cracked case on the ECM. If you silicone the case before the damage to electronics is done, you may salvage the module. Once the module deteriorates, starting becomes harder and harder during wet weather and eventually will not start at all. This problem has been seen on many vehicles andthe most likely reason for your symptom.
ON the side of the motor behind the starter.
try the fuel pressure regulator
where is the crank sensor located on a 2005 chevy impala
Depends what year... 99 its right by harmonic balancer in front of motor. 03 its behind stater...
To replace the window crank handle in a Chevy 2500 Express, first, remove the small retaining clip or screw that holds the handle in place. Use a flathead screwdriver to gently pry off the handle if it's tight. Once removed, slide the new crank handle onto the window regulator shaft and secure it with the clip or screw. Finally, test the handle to ensure it operates smoothly.
Chevy did not use a crank sensor on that year.
trying to locate crank shaft sencor for 1993 Chevy lumna trying to locate crank shaft sencor for 1993 Chevy lumna
a Chevy 350 crank is a Chevy 305 crank. they have the same stroke, 3.48 inches, and are interchangable. swapping between the two cranks does not change the engines displacement
Just the crank. The flywheel is neutral.
No.
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
A crank sensor was not USED on a 1995 model.