After learning that our Ford dealer would charge us $40 to tell us the factory unlock code, I looked on the computer module. The code sticker is NOT on the front of the module. However, I was able to locate it on the back. Here's how:
Remove the three hex head screws under the front edge of the panel below the steering column. One of the screws is behind the hood release lever. The panel is also attached with clips at the top edge; just pop these out.
The computer module is the same black box that has the fuses -- it says "pull" on the front where you can take the lid off to change fuses. The factory keypad code sticker on our car is on the BACK of the box, near the left side. Tos see it, I had to partially remove the box.
It's not necessary to unplug any of the cables from the box, but you need to remove the three nuts that secure the box. They are 10mm nuts, & you'll need a deep socket. One nut is at the bottom, one at the top near the upper right corner, and one on the left near the top. That last one is the least accessible, but it's not too difficult.
Get the nuts off, pull the box forwards until you can reach behind it with a small hand mirror to read the code. It's a 5-digit number & should be obvious. The numbers will be backward (in the mirror) and possibly upside down, so note carefully. I had a hard time figuring out whether one digit was a 6 or a 9, so I just tried it both ways, also forwards and backwards, until one of the combinations worked.
Then just replace the nuts & the dash panel, & use the factory code to reprogram the keyless entry code as explained in the manual. Be sure to write down the factory code somewhere safe.
The GEM module is to the left of the steering column.
find body control module its on that
The computer module, also known as the Engine Control Module (ECM) or Powertrain Control Module (PCM), on a 2005 Ford Five Hundred is typically located in the engine compartment. It is usually mounted on the passenger side, near the firewall or fender area. Accessing it may require removing some components for better visibility and reach. Always consult the vehicle’s service manual for precise location and removal instructions.
Where is the PCM located on a 2005 Mercury Montego Premier?
The instrument cluster is also the body computer.
It is part of the fuel pump module in the tank.
i own one and my dealer told me that the computer is inside the driver's door.
The fuel filter is part of the pump module in the fuel tank.
Under the dash behind the radio mounted on the firewall , move some insulation out of the way from the drives side look up with a flashlight and a mirror to find the 5 digit code on the door module. Save yourself $50 from the dealer is what I was quoted .
I'm not 100% sure, but try the right side kick panel. (the little panel in front of the door, under the dashboard) Or another way of explaining it's location is to the right of the accelerator pedal.
The computer module for the keyless entry code on a 2005 Ford Taurus SEL is located in the trunk of the vehicle. Specifically, you can find it behind the driver's side trim panel, near the rear tail light assembly. To access it, you'll need to remove the trim panel to reveal the module, where the keyless entry code is typically printed on a label.
It's located just above the brake pedal near the steering column