i believe its a 4 inch. i just recently bought a 74 f250
I need to know this as well !! hope somrone knows
bolt pattern orlug size for 1975 ford f250 highboy
Highboys have 3" wide front springs and 2.25" wide rear springs. Lowboys after 1977.5 have 3" wide front and rear springs.
The oil dipstick for a 1976 Ford F250 Highboy 4x4 with a 360 engine typically measures around 25 to 26 inches from the tip to the cap. However, it's important to note that variations can occur based on specific models and aftermarket parts. For the most accurate measurement, it's best to consult a repair manual or measure an original dipstick from the vehicle.
no, ford highboy line was a 3/4 ton deal and only thru 77.5
The Ford "HighBoy" is referring to a Style of Ford F-250 made thru the Mid-70's. This Truck Varied From the Original F-250. The Ride Hieght of this Truck is Greater. This Truck uses a NP 205 Divorced Transfer Case. You Can Tell the Highboy From the Regular F-250 By the Transfer case configuration. The Divorced Case Means there is a Driveshaft between the Transmisson and the Transfer case. ALL highboys are made this way. The highBoy also uses a Reverse Rotation Pinion setup in the Front Differential. This is a Very Strong setup as it allows more pinion and ring teeth to be combined at one time. The Gear Ratio on the Highboy is what Ford Calls 409. Most people call it 410. The Highboy also Features 1 Ton Hubs, Dana 60 or 70 Rear end. This is a very good Truck for those who want a strong truck. Still a Few around!
doggy highboy Monika
tallboy or highboy
nada.com
yes, u can make anything fit if you know what you are doing
When I leave our local garbage dump the empty weight of my 75' ford highboy is 6100lbs. I weigh 190lbs so about 5900lbs give or take.