answersLogoWhite

0

The 390 Ford motor is an FE block and was made as a Big Block only. The small block or Windsor motor could be bored and stroked to have 390+ cubic inches. To build a stroker motor you have to do extensive machine work and parts matching. That process usually involves large amounts of money.

User Avatar

Wiki User

16y ago

What else can I help you with?

Trending Questions
How many quarts of oil for an oil change in a Chrysler 300 v6 3.5 engine? Blazer rack and pinion were can it leak? Where is the horn in a 2002 voyager? Where is the drain plug for the radiator on a 2003 Chevy Monte Carlo? In a Pontiac grand am how do you know which front wheel bearing is bad? Where is the Engine Cooling Fan Relay in a 1996 Lincoln Continental? I have a 99 buick century and at slow speeds the rear end wobbles back and forth and at high speed the car vibrates any suggestions? Where is the fuse box located in a 1998 ford mustang? Is the 2008 Chevrolet Malibu front wheel drive rear wheel drive or four wheel drive? How much horsepower does a 2000 V6 Mustang have stock? Is the GM 4.8 vortec an interference engine? How do you remove a steering wheel on a 1998 GMC Truck? How do you replace the ignition switch in steering column on a 1990 Chevy Beretta? Tachometer wont operate Lincoln mark viii 96? How do you add refrigerant in Oldsmobile Regency 98? On a 2000 Cavalier the trunk release lever does not open the trunk and after tracing it back saw that the cable is not connected on inside of trunk and need help figuring out how to connect it? How many gallons does the gas tank in the 2006 Ford F-250-Super-DUTY hold? Where is the positive ground wire located on a 1983 Chevrolet celebrity? 1996 Jimmy heater fan blows mainly out the defroster and will sometimes not switch to the foor vent or dash vent Where can you trace this problem to? Which fuse is for the dash lights on BA falcon?