Factory unit is sealed without grease fittings
Replacements have grease fittings
all the ball joints are self lubricated, meaning no grease fittings, you cannot grease them or the steering joints, you can grease the front and back u joints on the drive shafts,but that is all.
There are no grease fittings on the new cars as the ball joints and steering assembly is maintenance free.
that vehicle has a total of 11 grease fittings. two upper ball joints two lower ball joints, two outer and two inner ball joints, two on the idler arm and one on the pitman arm.
Newer cars don't have grease fittings anymore, the ball joints are a sealed unit.
A grease gun end goes right on the fittings.
Yes, you can grease ball joints without grease fittings by using a method called "bulk greasing." This involves removing the ball joint from the vehicle and applying grease directly to the joint or through the rubber boot, if accessible. However, this method is less effective than using grease fittings, as it may not adequately lubricate the internal components. Regular inspection and maintenance are essential to ensure the longevity of ball joints without fittings.
There aren't any.
Aftermarket replacement parts will come with grease fittings such as tie rod ends, ball joints, etc.
tie rods may be ball joints that is all
Late model Chrysler mini-vans do not have any "grease fittings" the ball joints and tie-rod ends are sealed and do not require grease. They do not last forever ao be aware that the after market replacements for the ball joints often have grease fittings. They are located at the bottom of the joint and may require that the wheel be removed to gain access.
To grease ball joints on a vehicle, you would typically use a grease gun to inject grease into the fittings located on the joint. Make sure to use the appropriate type of grease specified for your vehicle and apply enough grease until you see it coming out of the joint. Check your vehicle's manual for specific instructions on how to grease the ball joints properly.
If any, they will be on the ball joints and tie rods.