I've replaced one before, you don't need to lift the engine, but there is some there is some crazy angles to work with.
45 thousandths
Yes. You will need to mount the engine 60degrees, however.
The 1994 Pontiac Sunbird 3.1 liter engine windshield washer pump can be found on the firewall in the engine compartment. The windshield washer pump will be on the drivers side firewall.
Replace the Harmonic balancer
In a 1994 Pontiac Sunbird SE with a 3.1-liter V6 engine, the thermostat is located near the engine block, specifically at the junction of the upper radiator hose and the engine. To access it, you'll typically need to remove the upper radiator hose and the thermostat housing. It's advisable to drain some coolant before removing the housing to avoid spills.
The firing order for the 1994 Pontiac Sunbird with a 3.1-liter V6 engine is 1-2-3-4-5-6. This means that the cylinders fire in that specific sequence to ensure proper engine operation. The cylinder numbering typically starts from the front of the engine, with cylinder 1 on the passenger side.
on the right side of the block just above the trany The sensor is located just above the manfol.
Check the computer that happen to me on a suzuki, the computer was burned. You can find it on a junk yard.
I have a 1990 Pontiac sunbird and i was only able to find one, it was behind the exhaust manifold on the block. I myself am having problems finding the other. I hope this helps.
For a 1994 Pontiac Sunbird with a 2.0-liter 4-cylinder engine, the frost plug (also known as a freeze plug) typically has a diameter of 1.75 inches. However, it's always best to verify the size by checking the specific service manual or consulting with a parts dealer to ensure accuracy, as variations can occur.
The firing order for a Pontiac Sunbird with a 2.0-liter engine is 1-3-4-2. This means that the first cylinder fires, followed by the third, fourth, and then the second cylinder in that sequence. This firing order is typical for many four-cylinder engines, helping to ensure smooth operation and balance.
make sure the throtle cable is adjusted correctly