Pull the motor or pull the transmission, one of them has to come out.
yes
It can be hard to locate all of the little parts of a vehicle. The freeze plugs of a 1995 Chevy are located within the rear of the motor to the car.Ê
there are 8 freeze plugs on the water jacket and 6 oil freeze plugs however you will have to pull the engine to get to the back of the motor to replace the 3 oil and 2 of the water jacket plugs
At minimum, removing the engine mounts is required to access the freeze plugs.
It is impossible to do it you have to pull the engine
Freeze plugs
There are three of them behind the motor and sum on both sides of the motor in front of the motor.
To change the freeze plugs on a 1995 Chevy G20 Van, first, drain the coolant from the radiator. Then, remove any components obstructing access to the freeze plugs, such as the intake manifold or exhaust components if necessary. Using a hammer and a punch or a specialized freeze plug tool, carefully tap the old freeze plugs out, and clean the area. Finally, install new freeze plugs by tapping them in place evenly, reassemble any removed components, and refill the coolant.
305 Chevy freeze plug locationthere should be two on each side of the motor just under the manifoid and two at the back of the motor bbetween the tranny housing and the motor behind the flywheel.
There right on top of the motor
It has 8 freeze plugs.
Replace the freeze plugs.... All of them. Chances are if one has rotted through, the others aren't far behind.