answersLogoWhite

0

Your hubs should have a "Locked" and an "Auto" setting. Under normal conditions, you should run in auto. Then if you need 4-wheel drive, flip the switch. Should the switch ever malfunction or go out, you have to manually lock and unlock (auto position) the hubs.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Are 1993 Jeep Grand Cherokee Limited vehicles constantly in 4 HI or 4 Low or can you place them in N on the 4 wheel drive selecter and drive?

It will not move in neutral. You have to be in 4hi or 4lo.


Will it improve accceleration to switch from a automatic transmission to a manual one?

Yes and no. A manual transmission uses less HP to turn the wheels than an automatic but you have to be able to drive it well to make up for the ease of an automatic. If you can half way drive a manual the answer is usually yes.


How do you switch out an automatic transmission with a manual transmission on a 1992 Toyota Paseo?

You don't if you're going to drive it on the street, it's cheaper to buy one with a manual transmission.


How do you disengage shift on the fly hubs?

If the truck has ESOF (electronic shift on the fly) just let up on the throttle and turn the switch to 2WD, the hubs will unlock by themselves assuming the manual override knobs out at the wheels have not been set to "lock". If so, those will have to be turned to "unlock" as well. If non ESOF, make sure the floor shifter is in the 2 wheel drive position, then get out and turn the hubs on the wheels to "unlock". If the above does not work for either type of system , there is an issue with the manual hub locks at the wheels and you will need to get them looked at.


My Renault clio automatic wont go into park and to select drive you have to pull back just before drive on the selecter what is wrong?

This is a common problem with the modern automatics ,they are mostly cable operated . Its a simple thing to adjust the cable referance Haynes manual. I have experienced this many times its rare but you may have to replace the cable. good luck & god bless.


How to unlock usb flash drive ps3?

To unlock a USB flash drive on a PS3, first ensure that it's formatted to FAT32, as the PS3 only recognizes this format. If the drive is locked with a password, you may need to use a computer to access the drive and remove the password protection. If it's a hardware lock, check for a physical switch on the drive itself. Once unlocked, plug it back into the PS3, and it should be accessible.


How do you unlock a verbatim store n go flash drive?

how do i unlock a store and go usb drive


Why does the 4 wheel drive lights blink on 1994 Chevy blazer?

First thing I would do is to trie puting it into drive or reverse to maybe it will kick in. If that doesnt work. You might have a bad 4 wheel drive selecter. Its a little black box on the side of the transfer case.


Where is the 4 wheel drive switch located on 2000 Jeep Grand Cherokee?

On a 2000 Jeep Grand Cherokee, the four-wheel drive switch is typically located on the center console, near the gear shifter. Depending on the model, it may be a lever or a dial that allows you to switch between two-wheel drive and four-wheel drive settings. For models equipped with Quadra-Trac or Quadra-Drive systems, the switch may also have additional settings for different terrains. Always refer to the owner's manual for specific details regarding your vehicle's configuration.


Is there a switch to turn 4 wheel drive switch off if not what should you do to turn light off?

That would depend on the vehicle make, model, and options. Check the user manual that came with the vehicle, available online, or at the dealer.


How do you unlock drivelock HDD bay password?

i forget my passward, how unlock my drive


Is an FX4 F-250 automatically 4-wheel drive or is there a knob or shifter to change from 2hi and 4hi and 4low?

The FX4 F-250 is an automatic 4 wheel drive although there is also a manual system that you can use to switch from 2 wheel drive to four wheel drive.