It is located in the gas tank
you have to remove the battery and tray, remove the iner fender well, un bolt it and remove fluid lines. Then reverse the prcess.
i believe 5/16
As far as I know they do. Located along the frame rail on the driver side. Easy to see and change, just in and out lines on the inline filter. Remove and replace.
There are more than a dozen vacuum lines on your 2000 Chevrolet Tahoe 5.3 liter engine. A complete vacuum line diagram can be obtained from most Chevrolet dealerships.
Drop the fuel tank down, disconnect the fuel lines
95 Chevy Tahoe no rear brake have hard peddel bleed all the lines when i disconcet front line to abs i have rear brakes concet front line i have no rear but have front is my abs valve screwed up
Pull the door Hinges and disconect all electrical lines running through door and remove
Remove the old oil filter. Drain the oil and remove air cleaner housing. Place the car on Êa jack. Loosen the engine mounts. Raise the engine and loose the bolts on the motor mounts. Remove the engine shock and the two brackets securingÊthe oil lines. Remove the oil cooler lines.
Disconnect the battery. Drop the tank, it's right there hanging from the top of the tank. Remove the filer pipe and as much other stuff as you can, put a floor jack under the tank, remove the straps and lower the tank to remove the electrical and fuel lines. Then the pump comes out with just a couple screws and a little fighting the sealer.
There are little medal horse shoe clips that must be removed before you can remove the lines. Use a small screew driver, there is 1 per line.
You can not see them until you remove the plastic upper intake / Plenuem Then you will see small little plastic lines that come off of them, Mechanics call that the spider. There will be 4 injectors on each side of the spider center body./ injector housing.
There is a special inexpensive tool that you can purchase from any auto parts store for removing these lines. Without this tool you can damage the lines.