no only 78-up
On a 1986 Dodge Power Wagon, the oxygen sensor is typically located on the exhaust manifold or just downstream in the exhaust system, often before the catalytic converter. It is usually threaded into the exhaust pipe and can be identified by its wire connector. If you're having trouble locating it, checking the service manual for your specific engine configuration can provide further guidance.
they are on exhaust pipe one is upstream of catalytic converter and one after converter ,
For a 1977 Dodge Power Wagon, the smog equipment typically required includes a functional exhaust gas recirculation (EGR) system, a catalytic converter (if not already equipped), and a proper air injection system. Additionally, the vehicle should have a functioning PCV (positive crankcase ventilation) valve and appropriate emissions hoses. It's essential to check local regulations, as requirements can vary by state or region.
How do you replace the Catalytic converter on a 1991 Suburu Legacy L station wagon? Where I get the used parts?
The new catalytic converter and gasket for my 2005 outback wagon was $830 installed at an independent Subaru specialist. Are you sure that yours is not covered under warranty (80,000 miles, I think)
1977 Dodge Power Wagon
anyone looking to buy 1975 dodge power wagon e mail me. conniecain60@yahoo.com
No you are a dumba$$.
The 2001 Passat wagon uses 5.7 pints of oil to 6.5 oil. Do not overfill as that may cause overflow to damage the catalytic converter.
just type 78 Dodge Power Wagon in the search line, a bunch of sites come up.
The little boxes by fusible link in a 1985 dodge power wagon by firewall are voltage regulators.
The dodge D100,150,200,250,300,350 are all medium/heavy duty trucks which were produced as 2wd trucks, the power wagon badge was placed on those d100-350 trucks which came with 4x4 or full time 4x4.