answersLogoWhite

0

nope, not for a fan anyways, for alternator, water pump ect it does

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

How do you tighten the fan belt on a 84 fiero?

There is no fan belt on any year Fiero. Electric fan motor,


How to route fan belts on a 1984 Pontiac Fiero?

There are 2 belts on my 1984. Inside belt crank shaft to water pump to alternator, should be a 50". Outside belt crank shaft to A/C, should be a 40" belt.


Why does the Pontiac fiero GT overheat?

i have had fiero gts over heat all the time its like watching the sun rise too me normally its thermostat not opening but if that's not it then its the fan switch not telling the fan to turn on


Fan belt configuration for Pontiac Grand Prix gtp?

There is no fan belt it is all electric at least for 97 and later models.


How many amp does a stock fan motor pulls on an 86 Pontiac fiero?

The stock fan motor on an 86 Pontiac Fiero typically pulls around 10-15 amps of current when operational. It's always best to consult the specific technical specifications or manual for precise information.


How should it cost to replace a fan belt on a 1988 Honda CRX?

theres no fan belt on front wheel drive motors. only a fan motor


Were is the tensioner in Pontiac sunbird?

I believe it to be on the fan belt mechanisim..the pulley that allows you to adjust the tension.


Why is your fan not working in your 84 Pontiac fiero?

This is a pretty simple system The most common failure is the sensor But the relay located under the left front headlight or the fuse could fail And lastly the fan could be bad


Why does 84 Pontiac fiero over heat?

Three basic reasons The fan does not work The cooling system has an air lock (very common) Cracked head, this engine is notorious for doing this


What or where can you find the route or diagram for the fan belt on a 1988 Ford F-150?

Parts store


How do you replace the fan belt on a 1996 Pontiac Grand Am SE 4 cylinder?

you need to remove the top engine mount


How do you change the fan belt on a 1988 grand prix le?

use ratchet on square hole on tensioner to pull it back and loosen belt