0
What else can I help you with?
Where is oil pressure switch 1989 Chevy Camaro rs?
The oil pressure switch on a 1989 Chevy Camaro RS is located on the bottom of the engine hear the oil filter. It constantly monitors oil pressure and updates the computer on its status.
Where is the oil pressure sensor on a 1997 z28 camaro?
Its in under the alternator and next to the oul filter
Where is the fuel pump oil pressure switch sender on a 1989 camaro 2.8 v6?
Mounted right above the oil filter,
What if you have no power to the fuel pump on a 1992 camaro 3.1 v6?
Check fuse, relay and oil pressure sensor. In these cars this sensor will cut the fuel pump to save your motor if it reads too low oil pressure.
Do you know where the oil pressure sensor is located on a 1973 Chevy camaro?
most small blick chevys have the oil sensor on the back of the motor behind the intake just right of the distributor
What causes a 1989 Chevy Camaro not to have any oil pressure?
well i'd say it's a dead oil pump hands down
Where is the oil pressure sensor located on a 1989 GMC pickup?
Behind and to the right of the distributor.
Where is the oil pressure sensor on a 1995 camaro z28?
The oil pressure sensor on a 1995 Camaro Z28 is located on the engine block, typically on the driver's side, near the oil filter. It is usually threaded into the block and can be accessed from underneath the vehicle or from the top, depending on the specific configuration. If you're having trouble locating it, consulting a repair manual specific to your model can provide additional guidance.
Why does your oil light keep coming on your 2002 pt cruiser?
Oil pressure is low, oil pressure sensor has failedOil pressure is low, oil pressure sensor has failed
Where is the oil sending sensor on a 1994 camaro?
It is right next to the oil filter
Where is the low oil sensor located on a 95 camaro 3.4?
Sensor is located on the drivers side of the oil pan.
What does a knock sensor for a 1991 Chevrolet Camaro 305 look like?
the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.
