0
Does a 1997 dodge ram van 2500 have an idle screw and where is it?
Wiki User
∙ 11y ago
Idle is computer controlled, there is no adjustment screw.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the idle adjustment on a 92 Dodge Caravan?
There is no adjustment screw, idle is automatically controlled by the pcm.
Where is idle screw on 2002 dodge caravan?
There isn't one. The idle is computer controlled and is not adjustable.
Where is the idle screw on a dodge stealth?
below the air intake on the throttle body
How do you raise the idle on your 1997 dodge van?
The idle is automatic. If the speed is not corect then you have to fix the problem with the idle motor.
How do you adjust the idle speed on a 1995 Dodge Neon?
Idle speed is controled by the computer. Unless there is a screw on the throttle body it is not adjustable.
Why does a 1997 Dodge Stratus die at idle?
it could be your EGR valve.
What would cause a 1978 Datsun 280Z to idle at 2500 RPMs?
z idle adjustmentTurn the idle screw - on the intake manifold - clockwise to decrease rpm or counterclockwise to increase idle. You should also look around for a vacuum leak
Where is the idle adjustment screw on a 1987 Dodge Ram 50?
its on the driver side of the carb down at the bottom in the middle there is a metal plug you have to drill out to get to the screw
Where is the idle screw adjustment on a 2002 dodge neon?
there is no idle adjustment on the neons it controlled by the computer wich opens and closes the idle air control motor located on or near the intake
Where is the idle adjustment screw located on a 1997 ford contour?
It's usually next to the throttle body
Your 1997 dodge stratus 2.4L has a rough idle and wants to stall?
Check for a vacuum leak
How do you adjust idle on a Honda XR80?
Set idle speed to proper r.p.m, by adjusting the IDLE SPEED SCREW. Turn the IDLE MIXTURE SCREW or the AIR SCREW to for correct procedure, achieve highest speed and best response. The IDLE MIXTURE SCREW (FCR) controls fuel delivery to the idle port and the SCREW is located on the engine side of the carburetor slide. Turning the IDLE MIXTURE SCREW out will make idle and off-idle richer. Turning IDLE MIXTURE SCREW (CR, PWK, PJ, PE) controls the amount of air to the IDLE and SLOW CIRCUIT. This SCREW is located on the air cleaner side of the throttle slide and turning the SCREW out will lean the mixture and turning the SCREW in (clockwise) will richen the mixture.
