No.
Your fuel pump will be inside the gas tank.
Dodge doesn't use fuel switches. The fuel system is computer controlled with relays.
Haynes Manual
The fuel pump is located in the fuel tank, meaning you'll have to drop the tank in order to replace the pump.
To fix a fuel gauge on a 1991 Dodge Dynasty, first check the fuse related to the gauge to ensure it's not blown. If the fuse is intact, inspect the fuel sending unit located in the fuel tank, as it may be faulty or have a bad connection. Additionally, check the wiring and connectors for any corrosion or damage. If all else fails, consider replacing the fuel gauge itself.
WHERE DO YOU CHECK THE FUEL PRESSURE ON A 1991 DODGE STEALTH
I believe that the carburetor type fuel/ air ratio delivery system was replaced by Fuel Injection, no carburetor to the best of my knowledge.
You will known when the fuel pump is working on the 1989 Dodge Dynasty because the engine will get fuel from the fuel tank. If the fuel pump is not working, the motor will be unable to idle or run.
The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.
you should be getting at least 48 pnds of pressure that's what the specs are for that engine
To reset the Automatic Shutdown (ASD) relay on a 1991 Dodge Dynasty, first, disconnect the battery for about 10 minutes to clear any stored faults. Then, reconnect the battery and start the engine. This process can help reset the ASD relay, which controls the fuel pump and ignition system. If issues persist, it may be necessary to check for faults in the ignition and fuel systems.
The fuel filter is located behind the fuel tank.