answersLogoWhite

0

It's located on the center radiator support at the very front of the vehicle. It lives towards the radiator, on the center support, towards the bottom.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Location of iat sensor ford f-250 super duty 6.0?

its close to your bung hole


Where is the location of camshaft position sensor 1999 F-250 7.3?

the sensor is in the front timing cover of the engine on pass.side above the crank pulley,10mm wrench will remove


Where is the location of camshaft position sensor 2004 F-250 6.0?

behind the powersteering pump on the driver side it is hard to see


Where is the location of camshaft censor 1997 f-250 7.3?

location of camshaft sensor is on the front of the block above the bottom pulley wheel. this is easiest accessed from underneath the vehicle


Were is o2 sensor bank 1 sensor 2 on a ford f-250 5.4l?

On a Ford F-250 : Bank 1 is the passenger side of the engine Sensor 2 would be in the exhaust after the exhaust exits the catalytic converter ( downstream sensor )


Where is the Coolant sensor location on a 1995 ford econoline van 5.8L F-250?

Next to the lower radiator hose where it connects to the water pump. You need to get under the vehicle to see it


Where is the iat sensor on a Ford F-250?

On a 6.0 diesel


Where is the intake temperature sensor on your 1991 ford f-250?

The air intake sensor on a 1991 Ford F-250 is located on the top of the engine. It is mounted just behind the distributor.


Installing cylinder head temperature sensor on f-250?

To install a cylinder head temperature sensor on a F-250, you disconnect the cylinder head sensor from the electrical connector at the rear of the cylinder head. When installing the new one, you reverse the process of removal. The cylinder head temperature sensor is located by the O2 sensor.


Where is crank sensor on 1996 Ford F-250 5.8?

What position is the crank sensor on a f250 ford pickup


What does code p2272 mean on a Ford F-250?

O2 Sensor stuck lean bank 2, sensor 2.


Do you have a free diagram for a f-250 throttle body?

My f-250 is bogging out when I give it any throttle I thought that it may be either the throttle position sensor or the air sensor that is located on the side of the throttle body?