I put an Edelbrock Torquer manifold on my 302 in a 1977 Cobra II Mustang ,
it didn't have a back water jacket and later my stock heads warped
( I SUSPECT that was the cause of the heads warping )
The front exhaust manifold is right in front by the spark plugs. The rear manifold is behind the engine by the spark plugs.
On the front and rear of what?? The Air Intake Manifold is on the TOP of the engine. the Exhaust Manifold are on the sides of an engine. On a front wheel drive vehicle, the engine is turned 90 degrees, so the exhaust manifold appears to be on the front and back of the engine, below the valve covers.
It is located on the front of the engine, under the intake manifold.It is located on the front of the engine, under the intake manifold.
With the edelbrock, use the vac line on the carb itself, It will be a small bore, 1/4 ( about ) vacuum line, and should be on the front of the carb.
Under the front exhaust manifold. You have to remove the manifold to remove the starter.
On the front of the manifold
It is a two wire sensor on the front pass side of the intake manifold. It is the one that is up high on the manifold and sits at an angle.It is a two wire sensor on the front pass side of the intake manifold. It is the one that is up high on the manifold and sits at an angle.
in front of manifold
The oil filter on the 2006 Toyota Sienna is in the front, pointing toward the front under the exhaust manifold. As you look under the hood from the front, it is in the center directly under the exhaust manifold.
The intake manifold, on your Jeep grand Cherokee, is located on the front side of the engine. The exhaust manifold is bolted to the engine.
it is located right in front of the car behind the fan.THAT'S THE EXHAUST MANIFOLD, THE INTAKE MANIFOLD IS ON THE *..BACK..* OF THE ENGINE. FOLLOW THE AIR INTAKE.
Front of the engine, just below the exhaust manifold.Front of the engine, just below the exhaust manifold.