The shift linkage is either broken or out of adjustment. Check the linkage where it connects to the transmission and make sure that it is connected properly.
will a gear shifter fork plate on 89 ford f150 work on 96 ford f150
The shifter linkage is loose or the drive gear is worn out.
A 2003 Ford F-250 column gear shifter can be fixed by simply tightening it again. You can tighten it by turning the adjustment wheel on the lower right side of the steering column.
Ford Explorer Column Shifter Lever Bracket Repair
A good majority of the 1984 Ford F150 gear ratio had 3.00 gears for the stock. In addition, the spline should be a 31.
It may just be a screw came loose underneath your gear shifter. That is what happened to me. Just slide the stuff up to the top of your gear shifter and look underneath. If one of the bolts is udone, just simple put it back on.
shift forks common problem 30 or 40 a peice. or your rubber bushings and set pins are bad at the bottom of shifter where it goes into top of tranny. 20 some dollar fix from allstategear.com
Not really describing answer , but i would assume you shifter cables have broken
i have 2003 ford ex cape and my ford ex cape i cant get the shifter to go into gear what possibly could be wrong
shifter is broke. my ranger was the same way. take the shifter off , and the ear on the other end will be broke. simple to fix. jus find another shifter like i did.
they are gear to gear driven.
On my 2000 expedition it was a loose bolt. this bolt aligns the gear shifter with the transmission position. it is located under the dash, just follow the column, it will be on top of the column with a torx bolt (i believe it was a torx) anyways if you jiggle the gear shifter while looking up you will see where they connect together with a bracket with the culprit bolt. Note, make sure you use some locktite or you will have the same problem over and over again. sorry if this seems a little vage, it's late and just seen this question ;)