0
What else can I help you with?
What are the head bolts torque setting for a Ford ka?
2006 ford ka 1.3 rocam engin cylinder head torque setting
What are the Torque settings for ford ka rear hubs?
235 NM
Ford KA rear hub nut torque?
the torque is 235 nm (autodata) works out at 173 lb/ft
What are the torque settings for a KA Ford Laser 1982 cylinder head?
91Nm or 67ft/lb
Where is the horn on a ford ka?
On my 1997 KA (P Reg) my horn is either side of the middle of the steering wheel. i dont know whether newer KA's have changed the position, but most probably in the middle of the steering wheel. Hope this helps :)
What is the torque settings for ford ka rocam motor?
The torque settings for the Ford Ka Rocam motor can vary depending on the specific component being serviced. For example, the cylinder head bolts typically require a torque setting of around 20 Nm (15 lb-ft) for the initial stage, followed by an additional torque of 90 degrees for the final tightening. Always refer to the vehicle's service manual for the most accurate specifications and procedures.
When was Ford Ka created?
Ford Ka was created in 1996.
Where is the heater motor located on a ford ka?
heater blower situated in a ford ka
Does a Ford ka-1998 model have a timing belt?
Ford Ka's have a timing chain, not belt.
Where is the oil filter on a 2002 ford ka?
dependes on the model and engine dispacement on the ford ka.
Where are the timing marks on a Ford ka?
where are the timing marks on a ford ka 1.3 and how do i check the timing is correct
How replaced power seering pump in ford ka?
How to replace power steering pump on a ford ka
