Front wheel bearings are pressed in using a hydraulic press, no torque setting. However, the wheel hub retaining/axle nut that you need to remove and replace in order to change out the bearing needs to be torqued down to 233 ft-lb.
The torque setting for the rear wheel bearing on a 1999 Ford Focus is typically around 150 lb-ft (pound-feet). However, it's important to consult the specific service manual for your vehicle or check with a professional to ensure accuracy, as specifications can vary slightly based on the model and configuration. Always use a calibrated torque wrench for precise measurement when performing such tasks.
If this is the European Ford Focus Front hub nut torque is 300-332Nm.
the diameter of the bearing and the bore of the knuckle bore of the 2005 ford focus front bearing
90 lbs
173 ft/lbs
How do you replace front wheel bearing on a ford focus
Mk1 Focus Euro spec (not US), rear hub nut, the big one in the middle, 29mm socket, torque to 235Nm
233 Ft Lbs
Focus is a front wheel drive vehicle. The wheel bearings are of the sealed variety.It's pressed into the hub. Take it to a machine shop to R and R.
A wheel bearing could be going bad in a 2002 Ford Focus if a grinding or rubbing sound is heard. A trip to a mechanic is advised as a bad wheel bearing that's not fixed can lead to damaged brakes.
You need a bearing puller.
The hub is pressed in. Remove the knuckle with the hub and bearing in it and take it to local machine shop.